Applies to: DP1/DP2/CP4 door viewer

You may try the following steps to initially set up your EZVIZ door viewer with touch panel:

Step 1: Power on your device by pressing the power button.

Step 2: Click the "Settings" button on the screen.

Step 3: Tap "Network settings".

Step 4: Select the WiFi network you want to connect to.

Step 5: Enter the WiFi password until the connection is successful. Please ensure that your Wi-Fi password is less than 32 characters and excludes special characters.

If you fail to configure the device, we suggest you may check the below network requirements first:

1. Ensure that you have connected your mobile device to 2.4G Wi-Fi.

2. Ensure that your Wi-Fi network connection is good and functional. Most EZVIZ devices perform better when upload speed is greater than 2 mbps for each camera.

3. Ensure that your Wi-Fi network signal is good. Try to avoid obstacles and interference such as wall, elevator, microwave, washing machines, and Bluetooth devices.

4. Ensure that DHCP settings on your router is on.

5. Ensure that when you configure network, your EZVIZ device is close to your Wi-Fi router. We do suggest that you keep the distance shorter than 1.5 meter.

6. Ensure that the Wi-Fi security on your router is WPA or WPA2, and your Wi-Fi password is less than 32 characters and excludes special characters.

By following these steps, you can effectively troubleshoot and resolve issues with your EZVIZ door viewer's connection to Wi-Fi. If you need further assistance, don't hesitate to contact our support team for personalized guidance.

If you encounter a situation where the indoor monitor of the smart video doorphone reboots every time the lock is unlocked, please note that this appears to be a result of excessive lock power, as the power supply to the lock must not exceed 12V/1.1A to ensure smooth unlocking. If this is exceeded, please try the following to see if the problem can be resolved:

1. You can try lowering the screen brightness in settings > Screen and Image > Screen Brightness on the monitor.

2. If adjusting the brightness does not help, consider connecting a relay as described in the user manual. To do this, connect the relay to the lock terminals (indicated by a key symbol) on the back of the doorbell. Then, connect the other end of the relay to the positive and negative terminals of the lock.

3. Alternatively, you can try using a power supply with a 24V 1.5A input to see if that resolves the issue.

By following these steps, you should be able to address the rebooting issue with your indoor monitor. If the problem persists, please consider reaching out to our technical support team at support@ezviz.com for further assistance.