EZVIZ no longer supports Internet Explorer 10 or earlier versions, and the site may not behave as expected. Please upgrade to a newer browser.
Please kindly note that if you don’t have a hard drive installed, the NVR will keep beeping and can’t be disabled. If so, you may have to get an HDD to install and format.
If you have already installed an HDD, please check the HDD status by going to the monitor > Device Management > Advanced Settings > HDD. If it shows abnormal, please try to format it again and we do recommend you save a backup of important clips before formatting by going to Advanced Settings > Export.
Meanwhile, please also check below information:
1. IP address conflict can also cause beeping, so please go to Device Management—Advanced Settings, and confirm whether your NVR IP address conflicts with the IP addresses of other network devices in your home, if it is, please disable the Enable DHCP button to modify the IP address of your NVR.
2. Please ensure the firmware of your system is updated to the latest by going to Device Management—Advanced Settings—Maintenance—Upgrade.
3. Unplug and plug the power adaptor again, after that, click the Shutdown button then choose the Reboot button to reboot your system.
4. You may also try to default the system by going to the Device Management—Advanced Settings—Maintenance—Default.
